Tricks and tips for everyone


How do you clean a scuba mouthpiece?

How do you clean a scuba mouthpiece?

Regulators and Mouthpieces As an extra precaution, use alcohol or antibacterial mouthwash to sanitize the second stage mouthpiece. Swab the mouthpiece first, then scrub gently using a toothbrush with soft bristles. Rinse thoroughly, taking care not to press the purge button.

How do you disinfect snorkel equipment?

Dilute a tablespoon of bleach in a bucket of warm water. Soak the snorkel in the bleach solution for up to 30 minutes. Rinse thoroughly under running water. Allow the snorkel to air dry.

How do you remove corrosion from scuba gear?

Contributor. The proper vinegar solution is a 50/50 mix of white vinegar and water. Do not soak longer than necessary as it will strip damaged chrome. If you are boat diving, a very common but overlooked place where salt water gets into a reg is the tank valve.

How do you disinfect a scuba mask?

A simple solution The agency recommends disinfecting hard (non-porous) surfaces in a diluted solution of 1/3 cup of bleach to 1 gallon of clean fresh water, with a contact time of one minute.

How do you clean a moldy snorkel?

How Do You Clean Mold Off A Snorkel?

  1. First of all, make sure to weaken the bleach solution significantly. Mix approximately one tablespoon of 5% household bleach with a gallon of cold water.
  2. Once the 30 minutes are over, it’s time to fully rinse our snorkel. Make sure that all remains are washed away.

What do you soak scuba gear in?

SOAK. Soaking in warm water will help dissolve salt crystals, loosen dirt and debris, and make rinsing easier and more effective.

  • RINSE. Once all your gear is well soaked, remove it from the soaking container and rinse it thoroughly using low pressure fresh water from a hose or shower head.
  • DRY.
  • STORE.
  • How do you disinfect scuba gear?

    In general, equipment can be effectively sanitized by submerging it in a 1% bleach solution or using a cleaning product such as Steramineā„¢ tablets or any other quaternary ammonium compound. Be sure to use these products according to the manufacturer’s directions and then rinse the gear with fresh water.

    Is it necessary to always clean your snorkels after using?

    Cleaning Your Snorkel Mask After Each Use Sand, saltwater, and other abrasive materials can enter the grooves of the snorkel mask and damage the skirt, strap, and lens of the snorkel mask if they are not cleaned properly. This is why it is so important to clean the mask after each use.

    How do you clean a diving mask with toothpaste?

    How to Pre-Treat a New Dive Mask

    1. To remove the film, use a slightly abrasive agent like toothpaste.
    2. Take a thimble-sized amount of toothpaste and rub it on both sides of the DRY lenses.
    3. Rinse the lens while rubbing away the toothpaste.
    4. Once the toothpaste is rinsed away, DRY the lens with a clean towel or rag.

    Can you put snorkel gear in the dishwasher?

    Most snorkels can be cleaned in a dishwasher. It’s probably best to remove the clip that attaches to the snorkel mask since it could loose it’s flexibility. Place it in the upper compartment of your dishwasher and generally you should be fine.

    Related Posts