Kyoto2.org

Tricks and tips for everyone

Other

What size heater do I need for my pool?

What size heater do I need for my pool?

The pool’s surface area divided by three gives you the minimal BTU size recommended for that particular surface area. Continuing the example above with the 15 x 30 pool, after dividing by 3, you get 150. Therefore, the minimum size heater that is recommended for a 15 x 30 pool is 150,000 BTUs.

What size pool heater do I need for 16×32 inground?

Heat Pump Sizing Chart – Inground Pools

Pool Size (Feet) Summer 4 BTU’s Spring & Fall 5 BTU’s
Up To 10,000 Gallons 12′ x 24′ 50,000 BTU 50,000 BTU
Up To 15,000 Gallons 14′ x 28′ 85,000 BTU 85,000 BTU
Up To 20,000 Gallons 16′ x 32′ 85,000 BTU 110,000 BTU
Up To 25,000 Gallons 18′ x 36′ 110,000 BTU 125,000 BTU

How do I choose a pool heater?

Calculate the pool surface area in square feet by multiplying the length and the width of your pool. Then, use this formula to figure out the BTUs you’ll need your heater to put out: pool area (sq. ft.) x temperature rise x 12.

How long does it take to heat a 20000 gallon pool?

You have a 20,000-gallon pool and use a 125,000 BTU heater. Your water is currently 70 degrees F but you would like it to be a minimum of 80 degrees F. How long will it take before the pool water reaches 80 degrees F? 10 x 1.33= 13.34 hours of heating before the pool reaches 80 degrees F.

What size pool heater do I need for a 40000 gallon pool?

EXAMPLE: To raise the temperature to a 40,000 gallon pool 2o per hour, the heater should be approximately twice the capacity of a Model DR or F650-WP – selecting a Model CLM150-WP (1,500,000 BTU).

How many gallons is a 16×32 inground pool?

Above Ground Swimming Pool Water Volumes by Size
33ft Round 22,488 gals 25,700 gals
12x24ft Oval 5,948 gals 6,797 gals
15x30ft Oval 9,293 gals 10,620 gals
16x32ft Oval 10,573 gals 12,084 gals

What is the most efficient type of pool heater?

The Raypak Digital Cupro-Nickel Propane 266k BTU Pool Heater, model 14951, is not the least expensive on our list, but for good reason. As far as pool heaters go, this is the pinnacle. Its 266,000 BTU, propane-fueled, heat production is ideal for most residential above ground or inground pools.

How many kW Do I need to heat my pool?

kW power heat pump The heat pump should be able to heat the water by approx. 0.20 – 0.25 degrees per hour. It takes 1.16 Wh to heat one litre of water one degree, which means 11.6 kWh for a 10m³ pool. In other words, one kilowatt hour heats 862 litre of water by one degree Celsius.

How much gas does a 400k BTU pool heater use?

4 gallons an hour
For a typical size 400,000 BTU heater, that equals 4 gallons an hour.

What size is a 10000 gallon pool?

Common Pool Sizes and Its Capacity In Gallons

Pool Size US Gallons
30 ft. Rnd 21,240
12 ft x24 ft Oval 6,400
15 ft x24 ft Oval 8,000
15 ft x 30 ft Oval 10,000

Does a pool heater use a lot of electricity?

So, how much electricity does a pool heat pump use? About 5 kilowatts per hour per 100,000 BTU heat pump. For a general 100,000 BTU pool heat pump, the power you`ll utilize is approximately 5,000 Watts per hour. Typically, the National average for power stands at 13 cents for every kilowatt-hour.

Is a gas or electric pool heater better?

Efficiency and Installation By nature, gas heaters have a greater environmental impact than electric. However, electric takes longer to heat up your pool water and is less efficient in colder temperatures. This is because they rely on outside heat to warm up the pool water.

What is the most efficient way to heat a pool?

The fastest way to heat your pool is to use a gas pool heater and a solar cover. It’s like heating up your coffee in the microwave and putting a lid on it. No matter how you plan to heat your pool, you should at least have a solar cover (or liquid solar cover) to help you retain the heat.

Which is cheaper to run gas or electric pool heater?

The Cost of a Gas Heater vs Electric Heater Gas is typically cheaper than electric when it comes to the initial cost. However, it relies on the prices of natural gas and propane, meaning that despite the equipment being a bit on the less expensive side, the cost to operate a is usually more expensive in the longer run.

Related Posts