Tricks and tips for everyone


How do you repair peeling laminate on kitchen cabinets?

How do you repair peeling laminate on kitchen cabinets?

Use contact cement for the replacement of the laminate veneer pieces. Allow the contact cement to dry then place them together. Use a J roller to smooth it out then use a router to trim the edges. Proceed to sand the surface to allow for a smoother finish.

How do you fix a peeling kitchen door?

Squirt a small amount of waterproof adhesive between the substrate and the laminate. Push the laminate into the glue, and apply a heavy-duty masking tape to the repair. Wrap this around the door to the opposite side and secure it in place.

How do you fix peeling thermofoil cabinet doors?


  1. Pull Back the Thermofoil Layer. Have a helper hold the peeling thermofoil away from the MDF.
  2. Scrape the Cement. Scrape away dried cement from the MDF core.
  3. Apply the Contact Cement.
  4. Wait to Press.
  5. Press Together and Secure.
  6. Clean Up.

How do you fix a lifted veneer?

Use a thin piece of stiff material, such as this laminate edging, to scoop some glue. Push it under the veneer as far as you can and move it around. Apply glue as many times as needed to get a good thin coat under the wood. Wipe away any glue that oozes out with a damp cloth.

Why do kitchen doors delaminate?

Glue issues If a sufficient amount of glue was not used when the veneer was installed on the cabinetry by the manufactured, then the veneer surface will delaminate. Also, if there was not sufficient drying time or sufficient pressure applied to hold the veneer on the wood or MFD then the surface may pull loose.

Can kitchen doors be re wrapped?

To vinyl wrap your kitchen, a plastic coating is stuck onto raw MDF cabinet doors and drawers. It is one of the options available if you’re looking to refurbish your kitchen, along with having it fully replaced or spray painted.

How do you fix peeling cabinet doors?

  1. Unscrew the hinges from the cabinet with a screwdriver.
  2. Lay the door flat and peel back the laminate with your fingers as far as it will go.
  3. Apply solvent-based, waterproof contact cement to the exposed core as well as the underside of the laminate surface that you peeled away, using a small paintbrush.

Related Posts